Bladeshark Application Instructions

	Step 1 Remove all tape, wax and dirt from blade. Clean using a mild, non-oily solvent, such as naptha or lacquer thinner.
	Step 2 Lightly sand blade until smooth, using sandpaper included. Do not sand through fiberglass or carbon fiber layer.
	Step 3 Wipe sanded surface again with a clean solvent-dampened cloth, and allow to dry.
	Step 4 Without touching adhesive backing, carefully separate one corner of BLADESHARK™ from backing paper.
	Step 5 Position exposed corner of BLADESHARK™ on the blade, and lightly press it down. Pull remaining backing away while adjusting position so that adhesive surface contacts blade evenly. Position so that a uniform margin of the blade is left exposed around top, bottom and wide end of blade.
	Step 6 Using firm finger pressure, press BLADESHARK™ evenly onto the blade, working from center toward ends and edges.
	Step 7 Lay blade flat on a rolled up towel and apply heavy pressure with heel of hand or pound with fist to bond BLADESHARK™ firmly to blade. Allow to set overnight for best results.
	Step 8 Repeat above steps to apply BLADESHARK™ to opposite side of blade.